The Okuma Genos L300-MYW is a fully-equipped CNC turn-mill center with a reputation for rigidity and done-in-one productivity that has made the GENOS L series a staple in high-mix production and precision job shops. This 2018 machine combines an integral main spindle through a JIS A2-8 nose - 3.15" (80 mm) bore, 20.47" (520 mm) swing over the bed, a 10" chuck, and a 30 HP motor turning to 3,800 RPM - with a 12-station V12 radial live-tooling turret running to 6,000 RPM and 7.5 HP for milling, drilling, and tapping at any angle. Full C-axis plus a Y-axis (100 mm / 3.94" travel) enable off-center and contour milling, while a pickup sub-spindle (6,000 RPM, 2.09" / 53 mm bore) transfers the part for complete back-end machining without a second setup. X and Z rapids of 984 and 1,181 IPM keep non-cut time low, and Okuma's Thermo Active Stabilizer (TAS-C) holds tight tolerances through temperature swings. It is equipped with high-pressure coolant, an automatic door, a parts catcher, a bar feeder, turret air blow, and Machining Navi L-g.
Compared to a base two-axis Genos L300 - or Okuma's earlier LB-series turning centers - the L300-MYW is a categorically more capable machine, not just a newer one. Where a turning-only lathe needs a separate mill and a second operation to add flats, cross-holes, or a finished back side, this MYW configuration adds live tooling, full C-axis, a Y-axis, and a sub-spindle so a raw bar goes in and a complete part comes out in one cycle. The integral spindle replaces the belt-driven heads of older LB lathes for cleaner finishes and less vibration, and the modern OSP control with TAS-C thermal compensation and Machining Navi delivers accuracy and chatter control the previous generation could not match - a genuine multitasking upgrade at a used-machine value.