The TRAK TRL3060RX is a heavy-duty CNC toolroom lathe built around a simple idea: an operator should be able to grab a handwheel or run a program without moving the part. This 2025 machine swings 33" over the bed and 43.5" over its 15.5" removable gap, carries 60" between centers on a 16.5" center height, and passes 6.3" of bar straight through an A2-11 spindle - a combination that puts oilfield shafts, long rolls, and large flanged work inside a single setup. A 30 HP inverter-duty spindle drives two ranges, 20 to 415 RPM and 40 to 1,300 RPM, so low-end torque for big diameters and top-end speed for finishing both live on the same machine. Cross slide travel is 20.5" with 21.2" swing over the cross slide, rapids run 400 IPM in Z and 200 IPM in X, and the tailstock carries an MT#6 quill with 8" of travel. The ProtoTRAK RLX control is factory-integrated with electronic handwheels and a jogstick, so conversational programming, TRAKing, and true manual operation are all one machine.
Against the TRL 3060SX it replaced, the RX generation is a control-and-feel upgrade rather than a new casting. The SX ran the older ProtoTRAK SLX; the RX ships with the ProtoTRAK RLX, which brings a larger touch-driven interface, faster conversational part programming, and better on-screen verification before a single chip comes off an expensive setup. The practical difference on the floor is how quickly a one-off becomes a program: the RLX lets an operator rough a feature manually, capture it, and repeat it, where the SX generation pushed you to choose manual or CNC up front. Everything a toolroom buyer already liked about the 3060 - the 33" swing, the 6.3" through hole, the gap bed, the 30 HP two-range drive - carries over unchanged, so the RX is the same heavy machine with a materially better way to talk to it.